Chapter 2 - Installing the Yamaha CRW4001t Drive

4.Remove the front cover of a vacant half-height drive bay.

For details refer to the manual of your computer.

�

5.Slide the CRW4001t drive into the drive bay from the front.

At this time, be careful not to apply excessive force to the drive itself. Finger-tighten the four fastening screws, and check that there is enough room to connect the power supply cable, IDE interface connector, and AUDIO cables.

�

6.Connect the IDE interface connector.

Connect the 40-pin IDE interface connector to the IDE interface located on the rear panel of the CRW4001t drive.

Position the connector so that the colored line is at pin 1 (your lower right).

8