Chapter 1 - System Configuration

Chapter 1 - System Configuration

Before using the CRW4001t, make sure that you have all of the items on the list of included items.

In order to use the CRW4001t, you will require the following.

Computer

The following operating environment is required:

•An IBM/AT compatible computer with a 100 MHz or faster Pentium CPU (in order to write at 4x speed), or a 100 MHz or faster 486 CPU (in order to write at 2x speed)

•A vacant IDE interface connector

•A vacant half-height bay

•Windows 95

•Sufficient hard disk space

Note: You will need about twice as much space on your hard disk as that required by the data you wish to write to CD-ROM.

Software

Use writing software or packet writing software which supports the CRW4001t.

Tools

•Philips screwdriver

This is used to remove the cover of your computer, and to install the Yamaha CRW4001t drive.

•Long nose pliers

These are used to insert or remove the jumper pin when setting the MASTER/ SLAVE settings of the Yamaha CRW4001t drive.

Philips screwdriver

Long nose pliers

3