Yamaha CRW4416SX Chapter 3 - Installing the Yamaha CRW4416SX Drive, CRW4416SX drive settings, Chapter 3

Chapter 3 - Installing the Yamaha CRW4416SX Drive

CRW4416SX drive settings

■SCSI ID settings

The SCSI ID number is used so that the computer will recognize a con- nected SCSI device. You can assign 0 through 7 as the SCSI ID num- ber. Usually, “7” is reserved for the SCSI card ID number, and “0” is reserved for the ﬁrst SCSI device in the chain. Use a number between 1 and 6 for the CRW4416SX.

Use the switch on the rear panel to set a SCSI ID number. The factory set ID number is “1”.

Caution: If you are using other SCSI devices, be sure to use a unique ID number for each device. Be sure to turn off the power to the drive before you set the SCSI ID number.

Note: When you are using Windows 95 or Windows 98, and if the SCSI ID setting on the rear panel is the same as the number assigned to another SCSI device, the Plug and Play component of Windows 95 or Windows 98 will automatically assign an unused number to the CRW4416SX (SCAM protocol level 1).

CDR ID –

Pressing this switch repeatedly will decrease the SCSI ID number by one each time.

SCSI ID Number

Pressing this switch repeatedly will increase the SCSI ID number by one each time.