DME Setup Manual 19
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
DME64N/24N Network Setup via Panel Operation
DME64N and DME24N device group and IP address settings can be made directly via the device’s panel.
1Turn on the DME64N/24N power.
2Press the [HOME] key to display the main
screen.
3Press and hold the [UTILITY] key for more than 2
seconds to display the Utility screen.
4Press the [UTILITY] a few times until the Net
page appears.
5Use the [▲] and [▼] keys to move the cursor to
the parameters listed below and press the
[ENTER] key.
The corresponding editing dialog will appear. Make the
settings indicated for each parameter below, and press
the [ENTER] key each time to confirm and enter the
settings.
1 Master/Slave
Selects Device Group Master or Slave status.
Master: One device must be assigned as the Master in
each Device Group.
Slave: All other DME devices in the group should be set
to Slave.
nWhen DME64N/24N and DME Satellite units are
combined in a Device Group, be sure to assign a DME
Satellite unit as the group Master.
2 IP Address
Set the IP addresses of the DME devices. All DME
devices in the same Device Group must be set to the
same network address.
nWhen only one DME device (Master) is used, set the IP
address to “192.168.0.2”.
nThe subnet mask is fixed at “255.255.255.0”.
nThe host address can be set from 2 to 253 for the Master
device, and from 3 to 253 for Slaves.
nAlways use a private address (192.168.0.2. through
192.168.255.253) unless it is absolutely necessary to
use a global address. Consult with the network
administrator if it is necessary t use a global address.
3 Master ID
When a device is assigned as a Slave in Master/Slave
(1) above, this sets the host address for the Master
device in that group. This parameter cannot be set for the
Master device.
4 Link Mode
Make sure that “100Base-TX” is selected.
Appendix1
2
3
4
Network address Host address