DME Setup Manual 7
6
From the DME Designer main panel, click [Port] in the [Setup] menu to open the Port dialog box.
7Select “YAMAHA USB OUT 0-1” or “Yamaha DME NETWORK-1” in the [Tx] field, and “YAMAHA USB IN 0-
1” or “Yamaha DME NETWORK-1” in the [Rx] field, and click [OK].
8In the main panel window click [Network Setup] in the [Hardware] menu to open the Network Setup dialog
box.
9Make the following network settings, then click [OK].
1 MIDI Port List (Tx/Rx)
Select “YAMAHA USB OUT 0-1/YAMAHA USB IN 0-1” or “Yamaha DME NETWORK-1/Yamaha DME NETWORK-1” as the
DME port for the network settings.
2 Master/Slave
Selects Device Group Master or Slave status.
Master: One device must be assigned as the Master in each Device Group.
Slave: All other DME devices in the group should be set to Slave.
nWhen DME64N/24N and DME Satellite units are combined in a Device Group, be sure to assign a DME Satellite unit as the Group
Master.
3 IP Address
Set the IP addresses of the DME devices. All DME devices in the same Device Group must be set to the same network address.
nWhen only one DME device (Master) is used, set the IP address to “192.168.0.2”.
nThe subnet mask is fixed at “255.255.255.0”.
nThe host address can be set from 2 to 253 for the Master device, and from 3 to 253 for Slaves.
nAlways use a private address (192.168.0.2. through 192.168.255.253) unless it is absolutely necessary to use a global address.
Consult with the network administrator if it is necessary to use a global address.
1
2
3
4
5
Network address Host address