Foreword
Introduction to
the DME Satellite
Controls and
Connectors
Connecting to
a Computer
Audio I/O
Connection
Connecting to an
External Device Other Functions
References
References
DME8i-ES/DME8o-ES/DME4io-ES Owner’s Manual
42
LED Level Meter
<DME8i-ES>
<DME8o-ES>
<DME4io-ES>
Signal Delay
Input/Output Characteristics ANALOG INPUT CHARACTERISTICS
ANALOG OUTPUT CHARACTERISTICS
DIGITAL INPUT & OUTPUT CHARACTERISTICS
METERING POINT CONDITIONS MIN TYP MAX UNITS
INPUT 1–8
PEAK red LED: ON –3 dBFs
SIGNAL green LED: ON –40 dBFs
METERING POINT CONDITIONS MIN TYP MAX UNITS
OUTPUT 1–8
PEAK red LED: ON –3 dBFs
SIGNAL green LED: ON –40 dBFs
METERING POINT CONDITIONS MIN TYP MAX UNITS
INPUT 1–4
OUTPUT 1–4
PEAK red LED:ON –3 dBFs
SIGNAL green LED:ON –40 dBFs
from to CONDITIONS MIN TYP MAX UNITS
Analog input of Primary Master Analog output of the slave via EtherSound @ 48kHz 2 msec
Input Terminals GAIN Actual Load
Impedance
For Use With
Nominal
Input Level Connector
Nominal Max.before clip
<DME8i-ES>
CH INPUT 1–8
<DME4io-ES>
CH INPUT 1–4
–60dB
3k
Ω
50–600
Ω
Mics &
600
Ω
Lines
–60dBu
(0.775mV)
–40dBu
(7.75mV) EUROBLOCK
(5.08mm pitch)
+10dB +10dBu
(2.45V)
+30dBu
(24.5V)
*1.In these specifications, 0dBu is referenced to 0.775 Vrms.
*2.All AD converters are 24-bit linear, 128-times oversampling (Fs=48kHz)/64-times oversampling (Fs=96kHz).
*3.+48V DC (Phantom power) is supplied to CH INPUT EUROBLOCK connectors via each individual software
controlled switch.
Output Terminals Actual Source
Impedance
For Use With
Nominal
Output level Connector
Nominal Max. before clip
<DME8o-ES>
CH OUTPUT 1–8
<DME4io-ES>
CH OUTPUT 1–4
75
Ω
600
Ω
Lines +4dBu (1.23 V) +24dBu(12.28V) EUROBLOCK
(5.08mm pitch)
*1.In these specifications, 0dBu is referenced to 0.775 Vrms.
*2.All DA converters are 24-bit linear, 128-times oversampling (Fs=48kHz)/64-times oversampling (Fs=96kHz).
Terminal Format Data length Level Audio Connector
EtherSound EtherSound 24bit 100Base-TX 16ch input/16ch output @ 48kHz
8ch input/8ch output @ 96kHz RJ-45x2