CONNECTIONS

■Speaker cables

10 mm (3/8”)

1

2

1Remove approx. 10 mm (3/8”) of insulation from each of the speaker cables.

2Twist the exposed wires of the cable together to prevent short circuits.

■Connecting to the REAR and CENTER SPEAKERS terminals

Red: positive (+)

2

Black: negative (–)

 

1

3

1Unscrew the knob.

2Insert one bare wire into the hole in the side of each terminal.

3Tighten the knob to secure the wire.

Other connections

■Using this unit as a Dolby Digital or DTS decoder

Connect the OUTPUT terminals (MAIN, REAR, CENTER and SUBWOOFER) of this unit to the EXTERNAL DECODER or 6 CHANNEL input terminals of the external amplifier.

■Receiving the multi-channel signal from other equipment

1Be sure to move the EXTERNAL DECODER/ MAIN IN switch to the EXTERNAL DECODER position before you turn on this unit.

2Connect the OUTPUT terminal of the external amplifier to the 6CH INPUT terminals of this unit.

3Press TAPE/MD MON / 6CH INPUT repeatedly (or 6CH INPUT once) until “6CH INPUT” appears on the display.

•The signal on the main channel will be output to the MAIN OUTPUT terminals.

•The overall volume level will be controlled by DSP- E800.

■Using this unit as a power amplifier

1Be sure to move the EXTERNAL DECODER/ MAIN IN switch to the MAIN IN position before you turn on this unit.

2Press TAPE/MD MON / 6CH INPUT repeatedly (or 6CH INPUT once) until “6CH INPUT” appears on the display.

•DSP-E800 is regarded as 3-channel power amplifier. The REAR L, the REAR R, and the CENTER terminals can be used for the connection.

•The volume control of this unit will be bypassed.

E-12