Yamaha DTXPRESS III Setting Up

10
To prevent electric shock and damage to the devices, make sure the power is switched OFF on
the DTXPRESS III and all related devices before making any connections to the DTXPRESS III’s
input and output jacks.
Setting Up
■ Connecting the pads
Referring to the illustration shown below, connect the output cable from each pad to each Trigger Input J ack located on the rear panel of the
DTXPRESS III.
The Trigger Input Jacks are all labeled (1 KICK, etc.) so make sure you connect each pad to its corresponding Trigger Input Jack.
Standard set
to 6 RIDE
to 7 CRASH1
to 3 TOM1 to 4 TOM2
to 2 SNARE to 5 TOM3
to 8 HI HAT
to 1 KICK
to HI HAT CONTROL
Caution)
A cable equipped with a
stereo plug is required
when connecting the
Hi-Hat Controller.
The hi-hat drum pad clamp
can also be attached to
this arm.