Getting Started

You can customize the various settings of this unit using the setup menu.

y

If the setting you have selected are not appropriate, you can reset all settings to the initial factory settings (see “Resetting the system” on page 40).

Step 1: Inserting batteries into the remote control

3

1

2

1Open the battery compartment.

2Insert the two supplied batteries (AA, R6, UM-3) following the indications (+/–) inside the compartment.

3Close the cover.

Notes

•Insert batteries correctly according to the polarity markings (+/–). Batteries inserted in the opposite orientation may leak.

•Replace the exhausted batteries immediately with new ones to prevent leakage.

•Remove the batteries from the compartment if the remote control is not used for more than a month.

•If the batteries have leaked, dispose of them immediately. Avoid touching the leaked material or letting it come into contact with clothing, etc. Clean the battery compartment thoroughly before installing new batteries.

•Do not use old batteries together with new ones.

•Do not use different types of batteries (such as alkaline and manganese batteries) together. Read the packaging carefully as these different types of batteries may have the same shape and color.

•Dispose of the batteries correctly in accordance with your local regulations.

Using the remote control

Use the remote control within 6 m (approximately 20 ft) of this unit and point it toward the remote control sensor.

Within 6 m (approximately 20 ft)

Notes

•Do not spill water or other liquids on the remote control.

•Do not drop the remote control.

•Do not leave or store the remote control in the following types of conditions:

–places of high humidity, such as near a bath

–places of high temperature, such as near a heater or stove

–places of extremely low temperature

–dusty places

Step 2: Turning on the Power

1Make sure the power cable is plugged into an AC outlet.

2Turn on your TV and AV receiver.

3Select the appropriate input source of the AV receiver (refer to the manual supplied with your AV receiver).

4Press STANDBY/ON on the front panel or POWER ( ) on the remote control to turn on this unit.

➜The front panel display lights up.

5Set the TV to the correct video input (refer to the manual supplied with your TV).

➜The default screen appears on the TV.

English

15En