72
Registration Memory
5
Resetting the Electone to the Factory Preset (Power On Reset)
All current settings including Registration Memories can be deleted at once
by using the Power On Reset function.
1. Turn off the power.
2. While holding down the top left Data Control button, turn the power
back on.
DATA CONTROL DATA CONTROL
POWER
Be careful when using this operation,
since it erases all your existing data.
Always save your important data to a
floppy disk using M.D.R. (page 76) in
advance.
Restoring the Registrations Before Turning the Power off
Turning the Electone off erases all panel settings you have made. When the
Electone is turned on, Basic Registration 1 is automatically selected.
If you have made panel settings you wish to keep, save them to Registration
Memory before turning the Electone off.
You can, however, restore the panel settings that were made before the
Electone was last turned off.
1. Turn on the power.
2. In doing this, first be careful NOT to press any panel buttons (excepting
those in Basic Registration), then hold down the M (Memory) button in
the Registration Memory section and press D (Disable) button.
D.87654321
M.
/TO DISK
The Electone restores the registration settings before turned off.