Features and functions

●Lock mode of the Yamaha Security System has been selected. (See page 36 for Yamaha Security System lock and unlock mode selection procedures.)

●Clip is removed from the engine shut-off switch.

●Throttle lever is squeezed.

EJU31210

Throttle lever

Squeeze the throttle lever to increase engine speed.

1

1Throttle lever

Release the throttle lever to decrease engine speed or to return it to the idle position.

EJU36740

Cooling water pilot outlets

This watercraft is equipped with cooling water pilot outlets on the port (left) and starboard (right) sides of the watercraft.

When the engine is running, cooling water is circulated in the engine, and then it is discharged from the pilot outlets.

To check for proper operation of the cooling system, check that water is being discharged from the port (left) pilot outlets. If water is not being discharged from these outlets, cooling water may not be circulating in the engine. When this occurs, stop the engine and check for the cause. (See pages 41 and 88 for more information.)

TIP:

●If the cooling water passages are dry, it will take about 60 seconds for the water to reach the outlets after the engine is started.

●Water discharge may not be constant at idle, therefore, open the throttle a little to

check that water discharges properly.

EJU31260

Steering system

Your watercraft can be steered by turning the handlebars in the direction you wish to travel.

1

2

1Handlebar

2Jet thrust nozzle

When the handlebars are turned, the angle of the jet thrust nozzle is changed, and the direction of the watercraft is changed accordingly.

32