Yamaha GX-700 Automatic preset tuning, To recall a preset station, When the automatic preset tuning is completed;

Tuning operation

DISC 1 DISC 2 DISC 3 DISC CHANGE OPEN/CLOSE

PTY SELECT PRESET/TUNING/BAND A/B/C/D/E

VOLUME

DOWNUP

2

PROGRAM	B.BOOST	MUSIC	INPUT		INPUT
			FREQ PS/PTY/RT/CT MODE–PTY SEEK– START
			RANDOM	REPEAT	TIME
			HOUR	MIN
MODE	DOLBY NR	REC/PAUSE	AUTO/MANUAL	MEMORY	DISPLAY
			TIMER	TIME ADJ

STANDBY/ON	3
	1

DIRECTION

	1	2	3	4	5
	1	2	3	4	5
	6	7	8	PRESET
	6	7	8	9	0
	A	B	C	D	E
	TIME	PROG	R. TIME	EDIT	+I0
	MODE	REPEAT	RANDOM		TUNER	2
	DISC SKIP
		TUNER CD
	REC/PAUSE
			TAPE		DIRECTION
	CENTER/	TEST	PROGRAM	BASS	MUSIC
	REAR/DELAY			BOOST
	LEVEL
1	POWER	SLEEP	INPUT	VOLUME
	/I
						2

Memory back-up

The memory back-up circuit prevents the programmed data from being lost even if the AC supply lead is disconnected from the AC outlet or the power is cut due to temporary power failure. If, however, the power is cut for more than one week, the memory may be erased. If so, it can be re-programmed by simply following the Preset tuning steps.

Automatic preset tuning

You can make use of an automatic preset tuning function. With this function, the built-in tuner performs automatic tuning. Up to 40 stations are stored automatically.

1 Turn on the power.

2 Press INPUT or until “TUNER” (2, 8) appears on the display, or simply press TUNER on the remote control.

3 Press and hold MEMORY for more than 2 seconds.

* The “MEMORY” (6) and “AUTO” (4) indicators flash.

The tuner performs automatic tuning and searches FM and AM stations in that order. Received stations are programmed to A1, A2 ... A8 sequentially.

When the automatic preset tuning is completed;

The display shows the frequencies of the first preset station (stored to A1).

If you want to check the contents and the number of preset stations, follow the procedure of the section “To recall a preset station” on the previous page.

To recall a preset station

Simply follow the procedure of the section “To recall a preset station” on the previous page.

Notes

●The automatic preset tuning search will be performed through all frequencies until 40 stations are stored. If the number of received stations is less than 40, the search will stop after searching all frequencies.

*Since FM stations are searched for first, there may be a case that 40 preset stations are occupied by FM stations only.

●The tuner is originally set to search only RDS stations instead of all FM stations by this operation. (FM stations that employ no RDS network service cannot be programmed.)

However, you can change the setting so that the tuner can program not only RDS stations but also other FM stations. (Refer to page 24 for details.)

●With this function, only stations with sufficient signal strength are stored automatically. If the station you want to program is weak in signal strength, tune in to it with the Manual tuning method (in monaural) and program it by following the procedure of the section “To store stations” on the previous page.

●You can replace a preset station with another FM or AM station manually by simply following the procedure of the section “To store stations” on the previous page.

E-20