Yamaha GX-90VCD Connecting the AC supply lead, Connecting external components, (See figure 9 on page 9.), (See figure @ on page 10.), (See figure A on page 10.)

CONNECTIONS

Connecting external components

(See figure 9 on page 9.)

This system can be connected with external audio and video components. Make connections between this system and other components using RCA pin plug connector cables correctly, that is to say L (left) to L and R (right) to R. Also, refer to the owner’s manual for each component to be connected to this system.

Connecting the AC supply lead

(See figure @ on page 10.)

•After completing all connections, plug the AC supply lead into a convenient AC outlet.

•Unplug the AC supply lead from the AC outlet if the unit is not to be used for a long period of time.

English

SETTING THE VIDEO OUTPUT FORMAT SELECTOR (TV MODE) SWITCH

TV MODE

PAL

AUTO

NTSC

ANTENNA

FM GND AM

75Ω UNBAL.

CENTER MODE				SPEAKERS
				CENTER/REAR
	TV MODE			REAR R CENTER L REAR
SUBWOOFER		VIDEO SIGNAL
	OUT	MONITOR
		OUT
		OUT		DO NOT CONNECT THIS UNIT TO SPEAKERS OTHER
		VCR		THAN NX-C70 (CENTER) OR NX-E70 (REAR).
		IN
		LD/TV
		OUT
		MD/AUX	R	L
		IN		SINCE THIS UNIT
R	L			HAS AN ACTIVE
R	L			SERVO CIRCUIT
AUDIO SIGNAL				BUILT–IN.
AUDIO SIGNAL				DO NOT CONNECT
				IT TO SPEAKERS
				OTHER THAN
				NX–GX70.

FRONT

SPEAKERS

The Video-CD player on this system is designed for use with the NTSC and PAL television formats. Set this switch to the position for the format your monitor TV employs.

PAL: Outputs signals in the PAL format no matter which format (PAL or NTSC) the currently playing disc employs.

Set to this position if your monitor TV employs the PAL format.

AUTO: Outputs signals in the same format as the currently playing disc employs.

Set to this position if your monitor TV can be switched in between the PAL and NTSC formats automatically.

NTSC: Outputs signals in the NTSC format no matter which format (PAL or NTSC) the currently playing disc employs.

Set to this position if your monitor TV employs the NTSC format.

Note

Make sure to play back a disc which employs the same format that your monitor TV employs, otherwise a picture will not be played back normally.

TURNING THE POWER ON/OFF TO THIS SYSTEM

(See figure A on page 10.)

If the AC supply lead is connected to the AC outlet, this system can be turned ON and OFF (STANDBY mode) by pressing the POWER switch on the front panel of the main unit or the POWER switch on the remote control transmitter.

Automatic power-off function

The power of this system will be automatically turned off if there is no operation on the control parts of this system, no illumination on the graphic equalizer level indicators and no playback of CD or tape for about 30 minutes.

*This function is not available unless time setting is made on the built-in clock.

STANDBY mode

While the power is on, pressing the POWER switch (or the POWER switch on the remote control transmitter) switches the system to the STANDBY mode. (In this mode, the display shows only the time.) In this mode, main voltage is still present inside the system. If you want to switch off the system completely, disconnect the AC power plug from the AC outlet.

E-13