SETTING THE CLOCK

1

2

MEMORY

HOUR

TIME ADJ

Changes.sich

3

MEMORY

MIN

TIME ADJ

Changes.

sich

.

1 While the power is on, press the DISPLAY button to display the time. If the power is off, you can proceed to the next step.

2 While holding the TIME ADJ button pressed, press the HOUR button and set the hour.

*Press the HOUR button once to advance the time by 1 hour. Press and hold to advance continuously.

*To reverse the hour, press the button instead of the HOUR button.

3 While holding the TIME ADJ button pressed, press the MIN button and set the minute.

*Press the MIN button once to advance the time by 1 minute. Press and hold to advance continuously.

*The hour setting will not advance even if minute is advanced from “59” to “00”.

*To reverse the minute, press the button instead of the MIN button.

China and Singapore models use a 24-hour display. For General model, either a 24-hour display or a 12-hour display [shown by “AM (PM) 12:00”] is selected depending on the setting of the FREQUENCY STEP switch on the rear panel, so you cannot select a desired type freely.

In the event of a power failure or when the AC supply lead is disconnected.

The time display will go out, however, the clock will function for about 5 minutes without power supply. So you do not have to reset the time if the AC power supply is resumed within about 5 minutes.

When the AC power supply is resumed after more than 5 minutes pass without power supply, the time display will flash on and off to indicate that the time must be reset.

ADJUSTING BRIGHTNESS OF THE DISPLAY

If desired, you can adjust brightness of the display.

1 Press and hold the DISPLAY button for more than 2 seconds so that “DIMMER±0” appears on the display.

2 Holding the DISPLAY button pressed, turn the VOLUME control clockwise to increase or counterclockwise to decrease brightness.

This adjustment can be made even though the power of this unit is off (in the standby mode).

Control range

When the power is on: ±0 to –6 (Preset value: ±0)

When the power is off: +3 to –3 (Preset value: ±0)

E-14