Appendix

CD playerTape deckRemote control

Problem

Cause

What to Do

 

A disc cannot be played

The disc is not a standard type.

Play another disc.

 

normally, or there is a noise

 

 

 

during play.

 

 

 

 

 

 

 

Play will not begin even if

Disc is upside down.

Load disc with label side facing upward.

 

disc is loaded.

 

 

 

Disc is dirty.

Clean disc.

 

 

 

 

 

No sound.

The input source selection is incorrect.

Select the CD player by pressing INPUT

or

 

 

button until “CD” lights up on the display.

 

 

 

 

 

Sound stops suddenly

Disc is dirty.

Clean disc.

 

(always at the same spot).

 

 

 

Volume is set too high.

Lower volume.

 

Tape will not move during

Slack tape wrapped around pinch roller.

Tighten slack with a pencil (pen) before using.

playback or recording.

 

 

 

 

 

 

Recording is not possible.

Erasure prevention tab is broken off.

Replace tape or cover erasure prevention hole with

 

 

adhesive tape.

 

 

 

 

 

 

Head is dirty.

Clean heads.

 

 

 

 

 

Sound is distorted or fades

Head is dirty.

Clean heads.

 

out, or stereo balance is poor.

 

 

 

Tape is worn.

Replace tape.

 

 

 

 

 

Poor sound quality.

Tape encoded with Dolby NR is played back

Press the DOLBY NR button to turn it on.

 

 

with this system’s Dolby NR off.

 

 

 

 

 

 

 

Tape not encoded with Dolby NR is played

Press the DOLBY NR button to turn it off.

 

 

back with this system’s Dolby NR on.

 

 

 

 

 

 

Excessive noise.

Head has become magnetized.

Demagnetize heads with head demagnetizer.

 

 

 

 

Tape travel stops in middle of

Slack tape coming out of cassette shell.

Tighten slack with a pencil (pen) before using.

playback or recording.

 

 

 

Tape is creased or torn.

Replace tape.

 

 

 

 

 

 

Endless tape is being used.

Do not use endless tapes.

 

 

 

 

The beginning of desired

Silent gaps between selections are too short.

The function of searching for the beginning of desired

selections on tape cannot be

 

selections will not operate unless the silent gaps

Excessively soft passages in middle of

found.

selections.

between selections are at least four seconds long.

 

 

 

 

 

Conversation, etc. is recorded.

 

 

 

 

 

Beginning of the track isn’t

There is an unrecordable part in the first few

Wind the unrecordable part of the tape and start

recorded.

seconds of the tape.

recording from the recordable part.

 

Remote control does not

Batteries are dead.

Replace batteries.

 

work.

 

 

 

Remote control is too far away or tilted too

Use within 6 m and 60° radius.

 

 

much.

 

 

 

 

 

 

 

Direct sunlight or lighting (of an inverter

Reposition the main unit.

 

 

type fluorescent lamp, etc.) is striking the

 

 

 

remote control sensor of the main unit.

 

 

 

 

 

 

TV functions strangely when

Remote control is being used near TV set

Relocate the main unit away from the TV.

 

the remote control is used.

with a remote control sensor.

 

 

 

 

 

 

E-40