H11 Owner’s Manual
50
ENGLISH
Keyboard Stand Assembly
3. Attach B.
3-1 Align the holes on A with those on B and hold A
and B together.
3-2 Finger-tighten six short screws (6×20 mm) start-
ing with the top hole.
3-3 Tighten the screws securely.
4. Attach C.
4-1 Align the holes on A with those on C and hold A
and C together.
4-2 Finger-tighten four short screws (6×20 mm)
starting with the top hole.
4-3 Tighten the screws securely.
5. Assemble the pedal structure.
5-1 Pass the pedal cord (that comes out from the rear
of pedal box E) through a hole on the bracket of
D, then pass it through the pipe.
5-2 Align the holes on the bottom of E with the holes
on the bracket of D, then attach E and D by tight-
ening six small screws (4×6 mm). At this time,
first tighten the two center screws, then tighten
the rest of the screws.
5-3 Pull the end of the pedal cord to eliminate any
slack inside the bracket on D.
CAUTION
Hold E securely to avoid slippage.
AB
AB
C
AA
DD
EE
DD
EE