ENGLISH
Keyboard Stand Assembly
H11 Owner’s Manual51
6. Install the pedal structure.
6-1 Remove the covers from the grooves on the bot-
tom surface of A.
6-2 Align the pedal power cords (that come out from
the pipes of D) along with the grooves on the bot-
tom surface of A.
6-3 Align the holes on the bracket of D with the holes
on A, then attach D to A by tightening four long
screws (6×30 mm).
CAUTION
Be careful not to pinch the cords between the bracket and
the surface of A.
7. Connect the cords.
7-1 Connect the pedal cord plug to the pedal connec-
tor in the correct orientation.
7-2 Set the voltage selector to an appropriate voltage.
7-3 Connect the power cord plug to the power con-
nector in the correct orientation.
Voltage Selector
Before connecting the AC power cord, check the
setting of the voltage selector which is provided in
some areas. To set the selector for 110V, 127V,
220V or 240V main voltages, use a “minus”
screwdriver to rotate the selector dial so that the
correct voltage for your region appears next to the
pointer on the panel. The voltage selector is set at
240V when the unit is initially shipped. After the
proper voltage has been selected, connect the AC
power cord to the AC IN and an AC wall outlet. A
plug adaptor may be also provided in some areas
to match the pin con��guration of the AC wall
outlets in your area.
8. Replace the groove covers.
8-1 Insert the pedal cord and power cords into the
grooves securely, then attach the groove covers.
A
AA
D
A
Correct
Incorrect