MV12/6 — Owner’s Manual
Front & Rear Panels 3
q
y
tt
o
u
e
ii
rr
w
Channels 1-8
(Monaural)
Channels 9-12
(Stereo)
Response [dB]
+5
+10
+15
–15
–10
–5
0
Frequency [Hz]
10k1k100 20k20
+20
–20
Front & Rear Panels

Channel Control Section

qGAIN Control

Adjusts the input level of the signal entering the mixer to an
optimum level.
To obtain an optimum balance between the S/N ratio and
dynamic range, adjust the level so that the PEAK Indicator w
occasionally lights.
-60 to -16 indicates the MIC input adjustment level, -34 to +10
indicates the LINE input adjustment level.
* The Input Select Switch located on the Connector Panel provides
settings for the type of mic or device that is connected to the INPUT
jack (refer to page 7).

wPEAK Indicator

The indicator detects peaks in the signal after it has passed the
EQ.
The indicator will light red when the level reaches +17dB to
warn that clipping is imminent.

eEqualizer

Provides +/-15dB of control over high, mid and low frequency
ranges at the center frequencies listed below.
HIGH : 10kHz (shelving)
MID : 2.5 kHz (peaking)
LOW : 100Hz (shelving)
Frequency response will be flat when the knob is positioned at
“G”.

rAUX1, AUX2 Controls

tPOST Switch

Individually controls the level of the signal sent from each
channel to the AUX1 and AUX2 buses.
The signal taken from before the channel fader is sent to
AUX1.
Depending upon the POST switch setting, the signal taken
from either before (POST Switch = ?) or after (POST Switch
= >) the channel fader is sent to AUX2.
When a stereo channel is used, L and R signals are combined
and sent to the AUX1 and AUX2 buses.