Yamaha MV12, MV6 8

MV12/6 — Owner’s Manual

8Front & Rear Panels

• AUX1, AUX2

These are impedance balanced phone type output jacks with a nominal output/impedance of +4dB/

600Ω. The AUX1, 2 bus signals are output from their respective jacks. These jacks can be used to send

the signal to monitor system such as a cue-box.

• EFFECT

This is an impedance balanced phone type output jack with a nominal output/impedance of +4dB/

600Ω.

The signal from the EFFECT bus is output from this jack. This jack can be used to send the signal to

an external effector, etc.

These are unbalanced phone type line input jacks with a nominal input level/impedance of +4dB/

600Ω.

The signal received by this jack is sent to GROUP buses 1-4, the STEREO bus and AUX1, AUX 2 buses.

Normally these jacks are used to receive the return signal from an external effector such as reverb, delay,

etc. but they can also be used as auxiliary stereo inputs. When only the L(MONO) jack is connected, the

same signal is sent to both the R and L jacks as a monaural signal.

These are line input jacks for monitoring an external DAT recorder or CD player. The signal that is

received by these jacks is sent to the stereo bus. In this case, the TAPE IN control is used to adjust the

input level. It is also possible to monitor directly from the MONITOR jack or PHONES jack by using

the PHONES/MONITOR output and the Meter Select Switch (Master Control Section) to make the

appropriate selection.

With an external DAT recorder or cassette recorder connected to these jacks, you can record the same

signal that is sent from the ST OUT jacks.

The signal sent from these jacks is not affected by the ST Mater Fader or Graphic EQ settings. Make

recording level adjustments on the recording device.

Sends the signal from the GROUP 1-4 buses. These jacks are used to connect to the input jack on an

MTR or an external mixer.

Two types of jacks are provided; balanced phone type and Euro-block connectors.

• Phone type (Tip: Hot, Ring: Cold, Sleeve: Ground)

Nominal output/impedance +4dB/600Ω

• Euro-block connector ( : Hot, : Cold, G: Ground)

Nominal output/impedance +4dB/600Ω

These jacks deliver the stereo output of the mixed signal and are connected to a power amplifier, etc.

that drives the main speakers.

The output can also be used for recording of the signal with the level of the signal being controlled by

the ST Master Fader.

Two types of jacks are provided; balanced XLR type and Euro-block connectors.

• XLR type (1: Ground, 2: Hot, 3: Cold)

Nominal output/impedance +4dB/600Ω

• Euro-block connector ( : Hot, : Cold, G: Ground)

Nominal output/impedance +4dB/600Ω