MV12/6 — Owner’s Manual
ST OUT
AUX 1
SEND
AUX 2 (PRE)
SEND
INSERT
IN
INSERT
OUT
PHONES
TAPE IN
REC OUT
INPUT
MONO OUT
12 Applications
Applications

Example 1) Basic Setup

Procedure

qConnect line input devices or microphones to the INPUT jacks and connect a power amp, that is
connected to the main speakers, to the ST OUT Jacks.
wUse the GAIN Control on each channel to adjust the level of the input signal from the device or
microphone that is connected to the input channel (refer to page 3), and use the Channel Fader to
adjust the level of the output signal that is sent to the Master Section. Basically, you should set the
Channel Fader close to the “0” position.
ePress each channel’s “ST” GROUP, ST Select Switch.
rUse the ST Master Fader to adjust the level of the signal sent to the power amplifier. Basically, you
should set the Master Fader close to their “0” position.
tUse the volume control(s) on the power amp to adjust the volume of the speakers.
If necessary, use a monitoring device (a pair of headphones, monitor speakers, etc.).
Microphone, Line Input GROUP 1-4 Faders
CD Recorder, DAT, etc.
Sub Woofer, etc.
Main Speakers
Power Amplifier Power Amplifier
Effector
ST Master Fader
PHONES/MONITOR Output and
Meter Select Switch
Monitor Speakers
Headphones
Set the POST Switch to “?”
(AUX2=PRE).
GROUP, ST Select Switches
Channel Faders
Power Amplifier