Keyboard Stand Assembly
2-3While supporting B with your hand, pass the pedal cord (attached to C) through from the inside to the outside of B.
Position C upside down, then insert it into the slot on B. Be sure to push C until it stops.
B
2-4While holding and pressing C securely into the slot, fix it to B using four long screws (6x20mm).
C
B
2-5Turn B so that its bottom side of (the side on which C is attached) is on the floor.
2-6Pass the pedal cord and power cord into the groove on B, then attach them to the top of B using the four vinyl ties.
Be sure to have the end of the power cord extend past the top edge of B by 20cm or more (roughly half the length of B).
At least 20cm
20cm
B
2-7Replace the plastic cover onto the groove of B. Do not insert the feet of the groove cover between the groove socket and groove wall.
B
Correct
Incorrect
3. Fix B to A.
3-1Place B in front of A, with the speaker net on B facing upward.
3-2Insert the speaker cord plug into the connector on the bottom surface of A, with the plug’s tab facing to the rear.
A
B
