HOW TO USE THE ACCESSORIES INCLUDED WITH THE SPEAKERS
| ■ Attaching the stand | ■ Attaching the spike |
Screw (6 mm) x 4 | Wood screw |
| (4 mm) x 4 |
Stand x 4 | Pad x 4 |
When positioning the speakers, be sure to use the stand to increase stability.
Use the 8 specified holes located on the base of the speaker.
Procedure:
➀Put the 6 mm screw through the larger hole on the stand, and attach to the speaker at one of the outside holes on the base of the speaker. At this time, attach the stand to
the speaker so that it can still be moved slightly.
➁Put the 4 mm wood screw through the smaller hole on the stand, and screw it into the inside hole on the base of the
speaker.
➂When both screws have been attached, tighten both of the
screws so that the stand is firmly in place.
Be sure to check that the stand is firmly attached.
➃Attach the pads to the bottom of the end portion of the stand.
➄Attach the other stands in the same manner and confirm that all 4 stands have been firmly attached.
➅Place the speaker in the desired location.
Note
If force is applied to the side of the speaker, it may fall and damage the speaker or cause personal injury. Please be careful.
Spike x 4
When setting up the speakers on a thick carpet, use the spikes instead of the stand. With 4 points set in place to achieve increased stability and improvements in sound quality.
Procedure:
➀Set the nut close to the tip of the spike and screw them into the bottom of the speaker at each of the four specified holes.
➁Place the speaker in the desired location in an upright position and adjust the length of the spike to match the
depth of the carpet.
➂When adjustment is complete, twist the nut up to the base of the speaker firmly.
Notes
●The tips of the spikes may scratch or otherwise damage the flooring. Please be careful when positioning the speakers.
●If force is applied to the side of the speaker, it may fall and damage the speaker or cause personal injury. Please be careful.
3