CONNECTIONS TO YOUR AMPLIFIER

Before making connections, make sure that the amplifier is switched off.

PLACING THE SPEAKERS

■Using as 2ch stereo speakers

Better stereo images will be obtained when the speakers are slightly angled in towards the listeners.

Loosen

Black (–)

Tighten

Red (+)

–+

Speaker

Speaker

(R)

(L)

 

 

SPEAKERS

 

 

R

 

L

 

Speakers output

 

 

 

A

terminals of the

+

–

–

+

amplifier

 

 

 

B

Amplifier or

Receiver

■Connections

●Connect the screw-type input terminals at the rear of the speakers to the speaker output terminals of your amplifier with the speaker cables.

●Connect the (+) terminals on both the amplifier and the speakers using one side of the cable. Connect the (–) terminals on both components using the other side of the cable.

●Connect one speaker to the left (marked L) terminals of your amplifier, and another speaker to the right (marked R) terminals, making sure not to reverse the polarity (+, –). If one speaker is connected with reversed polarity, the sound will be unnatural and lack bass.

Procedure:

➀Loosen the terminal knob.

➁Remove approx. 10 mm insulation from the speaker cable and insert the bare wire end properly into the terminal hole.

➂Tighten the knob.

➃Test the security of the connection by tugging lightly on the cable at the terminal.

Note

Do not let the bare speaker wires touch each other as this

4could damage the speaker and/or the amplifier.

■Using as main speakers in a multi channel system

Position the speakers on both sides of the TV. The positioning of speakers is important, because it controls the whole sound quality of a multi channel system. Set up the speakers on the basis of your listening position by following the owner’s manual supplied with your amplifier.

Front Effect

Speakers

Center Subwoofer

NS-120

NS-120

Rear Speakers