Yamaha NS-P320 USING THE SUBWOOFER (SW-P201), Rear panel, Controls and their functions, POWER, POWER, POWER, INPUT2, INPUT1, WARNING, AUTO STANDBY, 1POWER switch, switch

USING THE SUBWOOFER (SW-P201)

Controls and their functions

VOLTAGE

SELECTOR

220V-240V 8

110V-120V

Rear panel

POWER

OFF

	VOLTAGE	VOLUME
	SELECTOR
	POWER	7
ON	220V-240V	7
	110V-120V

OFF

2	STANDBY-RED	0	I0
	ON-GREEN

AUTO

STANDBY

3HIGH

			LOW
	VOLUME		OFF
STANDBY-RED	0 I0
ON-GREEN
AUTO	4
STANDBY		INPUT2	/MONO
LOW		INPUT2	/MONO
HIGH
OFF
INPUT2	/MONO
INPUT1
FROM AMPLIFIER	5
		INPUT1
TO SPEAKERS		FROM AMPLIFIER
OUTPUT

6OUTPUTTO SPEAKERS

1POWER switch

Set this switch to the ON position to turn on the power

of the subwoofer. When the power of the subwoofer is on, the power indicator (2) below the POWER switch

lights up GREEN. Set this switch to the OFF position to turn off the power of the subwoofer.

2Power indicator

Lights up GREEN when the POWER switch is set to the ON position and goes off when set to the OFF position.

*Standby mode

If the POWER switch is set to the ON position and the AUTO STANDBY switch is set to the HIGH or LOW position, this indicator lights up RED when no signal is inputted to the subwoofer.

3AUTO STANDBY (HIGH/LOW/OFF) switch

By setting this switch to the HIGH or LOW position, the subwoofer’s automatic power-switching function operates as described on the next page. If you do not need this function, set to the OFF position.

*Make sure to change the setting of this switch only when the POWER switch (1) is in the OFF

position.

Standby mode

The subwoofer is still using a small amount of power in this mode.

4INPUT2 terminalsUsed to input line level signals from the amplifier.

5INPUT1 (FROM AMPLIFIER) terminals

Used to connect the subwoofer with the speaker terminals of the amplifier.

6OUTPUT (TO SPEAKERS) terminals

Can be used for connecting to the main speakers. Signals from the INPUT1 terminals (5) are sent to

these terminals.

7VOLUME control

Adjusts the volume level. Turn the control clockwise to increase the volume, and counterclockwise to decrease the volume.

8VOLTAGE SELECTOR switch (General model only) If the preset setting of the switch is incorrect, set the switch to the proper voltage range (220V-240V or 110V-120V) of your area.

Consult your dealer if you are unsure of the correct setting.

WARNING

Be sure to unplug the subwoofer before setting the VOLTAGE SELECTOR switch correctly.

E-10