Automatic power-switching function
If the source being played is stopped and the input signal is | * The power might turn on unexpectedly by sensing noise | |
cut off for 7 to 8 minutes, the subwoofer automatically | from other appliances. If that occurs, set the AUTO | |
switches to the standby mode. (When the subwoofer | STANDBY switch to the OFF position and use the | |
switches to the standby mode, the power indicator lights up | POWER switch to switch the power between ON and | |
in red.) | OFF manually. | |
When you play a source again, the power of the subwoofer | * This function detects the | |
turns on automatically by sensing audio signals input to the | below 200 Hz of the input signals (i.e., the explosion in | |
subwoofer. | the action movie, the sound of the bass guitar or the | |
This function operates by sensing a certain level of low | bass drum, etc.). | |
frequency input signal. Usually set the AUTO STANDBY | * The minutes required to switch the subwoofer to the | |
switch to the LOW position. However, if the power is not | standby mode might change by sensing noise from | |
switched to ON or STANDBY smoothly, set the switch to the | other appliances. | |
HIGH position. In the HIGH position, the power will turn on | This function is available only when the power of the | |
even with a low level of input signal. But please be aware | ||
subwoofer is on (by setting the POWER switch (1) to | ||
that the subwoofer may not switch to the standby mode | “ON”). | |
when there is an extremely low input signal. | ||
|
Before using the subwoofer, adjust the subwoofer to obtain the optimum volume balance between the subwoofer and the main speakers by following the procedures described below.
Rear panel
3
POWER
ON
POWER |
ON |
OFF |
OFF
|
|
| VOLUME | |
| VOLUME |
|
| 1, 5 |
|
| 0 | I0 | |
0 I0 | ||||
|
| |||
AUTO |
|
|
|
|
STANDBY |
|
|
|
|
HIGH |
| AUTO |
|
|
LOW |
|
|
| |
OFF |
| STANDBY |
|
|
|
|
|
| |
INPUT2 | /MONO | HIGH |
|
|
|
| LOW |
|
|
|
| OFF |
|
|
1
2 Turn on the power of all the other components.
3 Set the POWER switch to the ON position.
* The power indicator lights up in green.
4 Play a source and adjust the amplifier’s volume control to the desired listening level.
5 Increase the volume gradually to adjust the volume balance between the subwoofer and the main speakers.
VOLUME
Note: It is recommended to set the
VOLUME control to the middle position when using all the speakers of this package in a 5.1-
channel home theater system.
0 I0
Once the volume balance between the subwoofer and the main speakers is adjusted, you can adjust the volume of your whole sound system by using the amplifier’s volume control.
However, if you change the main speakers