53
STORE
OVERWRITING IN PLAY MODE
1. In Voice Play mode, press the [STORE]
button. The LED above the [STORE] button starts
blinking. The following screen appears.
2. Press [+1/YES] if you want to overwrite the
current Voice and Performance parameter
settings. (Press [–1/NO] if you want to
cancel the store operation and return to the
previous mode.) The STORE
COMPLETED screen briefly appears to confirm the
store operation.
STORING A PERFORMANCE
1. In either Voice Play mode or Performance
Play mode, press the [STORE] button.
The LED above the [STORE] button starts blinking.
The following screen appears.
STORE
-1/NO +1/YES
PS1 PS2
STORE? (YES/NO)
Voices -› Voices
** STORE **
** COMPLETED **
STORE? (YES/NO)
A01 -› A01
When Auto Store is designated all parameter changes are
stored automatically as you make them. Thus, you can jump
back and forth between voices and Voice and Performance
modes freely as you play, since all settings will remain as
you set them. In this case, necessary storing is literally a
matter of copying one Performance to a specific
Performance bank and number.
When Non Auto Store is designated, in general the changes
you make to voices such as reverb and modulation settings
will be lost as soon as you change voices, Performances or
modes. After making changes in Edit mode, however, the P-
150 will prompt you and give you the opportunity to overwrite
the current edit when you try to leave Edit mode.
You will find it most convenient to set up your Performances
in Voice Play mode, Auto Store status, since voice selection
is so simple, then copy it to one of the 24 Performance
memories for instant recall when you need it.
By switching into Non Auto Store status, you can be sure
that your Performances are protected, and any changes you
make in one will not be applied unless you specifically store
it.
For details about changing the Store status, see page 11.
Note that there is a fine distinction between Voice Play mode
store and Performance Play mode store functions. In Voice
Play mode, you can overwrite the current set of Voice and
Performance parameter settings. In Performance Play mode,
you can select a specific destination Performance in which to
make a duplicate, or copy the current Performance
parameter settings. Therefore, if you select a destination
Performance in which to store the current Voice Play mode
Performance parameter settings, you are storing it in the
Performance Play mode.
Regardless of the Auto Store/Non Auto Store status, the parameter
changes made in the System, MIDI Filter and PC Table functions are
always stored automatically.