Yamaha P-80 F4

P-80

The Function Mode

F4.2: Split Balance.....................................................................................................................................

The volume levels of the two voices combined in the split mode can be adjusted as required by

using this function. Use the [–/NO▼] and [+/YES▲] buttons to adjust the balance as required. The

balance range is from 0 through 20. A setting of “10” produces equal balance between the two split-

mode voices. Settings below “10” increase the volume of the Left Voice in relation to the Right

Voice, and settings above “10” increase the volume of the Right Voice in relation to the Left Voice.

Press the [–/NO▼] and [+/YES▲] buttons simultaneously to recall the default setting (different for

each voice combination).

F3.5: 1st Voice Effect Depth............................................................................................................

F3.6: 2nd Voice Effect Depth..........................................................................................................

These functions make it possible to individually set the depth of the effect for the 1st and 2nd

dual-mode Voices (“1st” and “2nd” is explained on page 15). Use the [–/NO▼] and [+/YES▲]

buttons to set the effect depth for the corresponding voice as required. The depth range is from 0

through 20. A setting of “0” produces no effect, while a setting of “20” produces maximum effect

depth. Press the [–/NO▼] and [+/YES▲] buttons simultaneously to recall the default setting (differ-

ent for each voice combination).

NOTE

•The effect depth settings cannot be changed unless the EFFECT is ON. The Function mode must be

exited before EFFECT can be turned ON.

F3.7: Reset .........................................................................................................................................................

This function resets all dual-mode functions to their default values. Press the [+/YES▲] button to

reset the values. “End” will appear on the display when all functions have been reset.

F4 Split Mode Functions

After selecting “F4.Y”, press the [+/YES▲] button to engage the split-mode function sub-mode,

then use the [TEMPO/FUNCTION# ▼,▲] buttons to select the desired split mode function, as

listed below.

If the Split mode is not engaged “F4.-” will appear instead of “F4.Y” and the Split mode

functions cannot be selected. Also note that you must exit from the Function mode before the

Split mode can be engaged.

■ SHORTCUT:You can jump directly to the split-mode functions (F4) by pressing the

[FUNCTION] button while holding the [SPLIT] button.

NOTE

•Split mode function settings are set individually for each voice combination.

F4.1: Split Point ............................................................................................................................................

In addition to the split point setting method described on page 16, the split point can be set via this

function. Use the [–/NO▼] and [+/YES▲] buttons to set the split point as required, or simply press

the appropriate key on the keyboard: from “A-1” to “C7”. Press the [–/NO▼] and [+/YES▲]

buttons simultaneously to recall the default setting “F#2”.