PM1D Manager for Windows Operating manual
18
Windows Me
1. Start your PC and Windows, and insert the
included CD-ROM into your PC’s CD-ROM drive.
2. Power-off the console/engine, and use a USB cable
to connect the console/engine to the PC.
The USB connector of the console/engine is located
in the PC CONTROL section of the rear panel.
3. Turn on the console/engine.
The Add New Hardware Wizard appears. If it doesn’t
appear, try disconnecting and reconnecting the USB
cable. Alternatively, open the Add New Hardware
control panel.
4. Select “Automatic search for a better driver (Rec-
ommended),” and then click Next.
Windows Me should be able to locate the driver
automatically, in which case you can proceed to Step
5. If the driver cannot be located, select “Specify the
location of the driver (Advanced),” click Next, spec-
ify your CD-ROM drive (e.g., D:\USBdrv_), and
then continue as prompted.
The following window appears when the installation
is complete.
5. Click Finish, and then restart your PC.
Windows 2000
1. Start your PC and Windows, log on as the Adminis-
trator, and then insert the included CD-ROM into
your PC’s CD-ROM drive.
2. Go to My Computer→Control Panel→
System→Hardware→Driver Signing→File Signa-
ture Verification, select “Ignore-Install all files,
regardless of file signature,” and then click OK.
3. Power-off the console/engine, and use a USB cable
to connect the console/engine to the PC.
The USB connector of the console/engine is located
in the PC CONTROL section of the rear panel.
4. Turn on the console/engine.
The Found New Hardware Wizard appears.
5. Click Next.
6. Select “Search for a suitable driver for my device
(Recommended),” and then click Next.
7. In the subsequent window, select “CD-ROM
drives” only, and then click Next.
You may be prompted to insert your Windows CD-
ROM. Do not insert it! Click OK, and in the “Copy
files from” section of the subsequent dialog box,
enter “D:\USBdrv2k_” (replacing “D” with the
drive letter of your CD-ROM drive), and then click
OK.
The driver is installed, and the message “Completing
the Found New Hardware Wizard” appears.
8. Click Finish, and then restart your PC.