Using a Microphone — MIC. (PSR-2100 only)
133
PSR-2100

Operation

Adjusting the Vocal Harmony Settings and Microphone Effects —

OVERALL SETTING

The explanations here apply to step 2 above.
■3BAND EQ (3-BAND EQUALIZER)
Usually an equalizer is used to correct the sound output from amps or speakers to match the special character of the
room. The sound is divided into several frequency bands, allowing you to correct the sound by raising or lowering the
level for each band. The PSR-2100 features a high grade three-band digital equalizer function for the microphone sound.
Hz ..............Adjusts the center frequency of the corresponding band.
dB............... Boosts or cuts the level of the corresponding band by up to 12 dB.
■NOISE GATE
This effect mutes the input signal when the input from the microphone falls below a specified level. This effectively
cuts off extraneous noise, allowing the desired signal (vocal, etc.) to pass.
SW.............. “SW” is the abbreviation of Switch. This turns Noise Gate on or off.
TH.............. “TH.” is the abbreviation of Threshold. This adjusts the input level at which the gate begins to open.

Making Settings for the Vocal Harmony and Microphone

— MICROPHONE SETTING

BACK NEXT
I
F
J
G
H
D
A
E
B
C
1Press the [MIC.
SETTING]
button.
2Select the MICROPHONE SETTING page by using the [BACK]/[NEXT]
button and set the parameters.
For information on the various parameters and settings and
how to use them, refer to the explanations
below.
Press the [EXIT]
button to return to the
previous display.
END
I
F
J
G
H
D
A
E
B
C
81 2 3 4 5 6 7
Select the 3BAND EQ.
Use these to change the value for each
function or setting. For details, see below.
Select the NOISE GATE/
COMPRESSOR.
Select the VOCAL HARMONY
CONTROL/MIC.