Yamaha RX-396RDS/396 Exchanging Preset Stations, When the automatic preset tuning is finished

When the automatic preset tuning is finished;

The display shows the frequency of the last preset station. Check the contents and the number of preset stations by following the procedure of the section “To recall a preset station” on page 18.

To recall a preset station

Simply follow the procedure of the section “To recall a preset station” on page 18.

*RX-496RDS, RX-396RDS

A recalled station is shown by the frequency or station name on the display.

*RX-496, RX-396

A recalled station is shown by the frequency on the display.

Notes

●You can replace a preset station by another FM or AM station manually by simply following the procedure of the section “To store stations” on page 18.

RX-496RDS and RX-396RDS only

●The automatic preset tuning search will be performed through all RDS network frequencies until stations are stored up to E8. If the number of received stations is not enough to be stored up to E8, the search is finished automatically after searching all frequencies.

●With this function, only RDS stations with sufficient signal strength are stored automatically. If the station you want to program is weak in signal strength, tune to it in monaural manually and program it by following the procedure of the section “To store stations” on page 18.

*There may be a case that this function cannot receive a station which could be received by the automatic tuning method. This is because this function receives a large volume of PI (Program Identification) data along with the station.

RX-496 and RX-396 only

●If the number of received stations is not enough to be stored up to E8, the search is finished automatically after searching all frequencies.

●With this function, only FM stations with sufficient signal strength are stored automatically. If the station you want to program is weak in signal strength, tune to it in monaural manually and program it by following the procedure of the section “To store stations” on page 18.

EXCHANGING PRESET STATIONS

You can exchange the places of two preset stations with each other as shown below.

NATURAL SOUND STEREO RECEIVER

																										VOLUME
																									20	l6
																				TUNER			PHONO	CD		l2
																									28	8
STANDBY/ON
																									40	4
																				AUX			TAPE 2	TAPE 1/MD	60	2
																							MONITOR
		A/B/C/D/E	1			2			3			4		5	6		7	8								0
																										–dB
PHONES	SPEAKERS		BASS					TREBLE				BALANCE			LOUDNESS				FM/AM		DOWN TUNING UP
			l	0	l			l	0	l		l	0	l	l	FLAT	–30dB
	A	B
			2			2	2				2	2		2	2		l0
			3			3	3				3	3		3	3		9		MEMORY		EDIT	TUNING
																							MODE
	ON	OFF	4			4	4				4	4		4	4		8
			5		5		5			5		L 5		5 R	5 6 7				MAN’L/AUTO FM			AUTO/MAN’L MONO

2, 4

Example)

If you want to shift the preset station on E1 to A5, and vice versa.

1 Recall the preset station on E1 (by following the method of “To recall a preset station” on page 18).

2 EDIT

Flashes.

MEMO

3 Recall the preset station on A5 by following the same method as in step 1.

Flashes.

MEMO

4 EDIT

Shows the exchange of stations is completed.

20