Yamaha CDX-E400, RX-E400 p.8, p.18, p.23, p.23, Note, Notes, Notes, Receiver, RX-E400:, CD player, CDX-E400:, Remote control sensor, MD recorder, MDX-E300:, Cassette deck, KX-E300:

GETTING STARTED

Remote control	Remote control operation range
	VOLUME

English

This remote control controls a whole system: not only RX-E400 but also CDX-E400. Moreover, a cassette deck (KX-E300) and MD recorder (MDX-E300) that level up your system can be operated by it. Operating buttons for each unit are explained on the pages below:

Receiver, RX-E400:	p.8
CD player, CDX-E400:	p.18
Cassette deck, KX-E300:	p.23
MD recorder, MDX-E300:	p.23

	NATURAL SOUND STEREO RECEIVER				RX–E400
STANDBY/ON
TIMER	DISPLAY	MEMORY	AUTO/MAN'L	PRESET/BAND	PRESET/TUNING		MIN	MAX
		TIMER ADJ	TIMER		HOUR	MIN		INPUT
		BASS	TREBLE			BALANCE
PHONES
	–	+	–	+	L	R

Remote control sensor

Battery installation

1

3

2

1 Remove the battery compartment cover.2 Insert batteries into the battery compartment.3 Replace the battery compartment cover.

Battery replacement

If you find that the remote control must be used closer to the main unit than usual, the batteries are weak. Replace batteries with new ones.

Notes•Use only AA, R6, UM-3 batteries for replacement.

•Be sure the polarities are correct. (See the illustration inside the battery compartment.)

•Remove the batteries if the remote control will not be used for an extended period of time.

•If batteries leak, dispose of them immediately. Avoid touching the leaked material or letting it come in contact with clothing, etc. Clean the battery compartment thoroughly before installing new batteries.

Within approximately 6 m (20 feet)

30	°	°
		30

Notes

•There should be no large obstacles between the remote control and the main unit.

•If the remote control sensor is directly illuminated by strong lighting (especially an inverter type of fluorescent lamp, etc.), it might cause the remote control not to work correctly. In this case, reposition the main unit to avoid direct lighting.

Removing the protection sheet

The remote control is shipped with a protection sheet to prevent the surface from being scratched during transportation.

When removing the sheet, first put adhesive tape on an edge of the remote control so that the tape sticks to the sheet. Then peel the sheet off with the tape.

	W	ER								W	ER
P O			3						P O			3
					3									3
		2				6									6
							6				2					6
			2	5				9				2					9
		1									1		5
						5									5
		1					8				1					8
			4									4					8
					4			8						4
						7									7
								7									7

Note•Do not scratch the remote control surface when peeling the sheet off.

3