IMPEDANCE SELECTOR switch
Be sure to switch this only when the power of this unit is turned off.
Select the position whose requirements your speaker system meets.
|
| IMPEDANCE SELECTOR |
| VOLTAGE | ||||
|
| SET BEFORE POWER ON |
| SELECTOR | ||||
|
|
|
|
|
|
|
|
|
|
| REAR SINGLE:6ΩMIN. /SPEAKER |
|
|
|
|
| |
|
| REAR | :3ΩMIN. /SPEAKER |
|
|
|
|
|
| CENTER | :6ΩMIN. /SPEAKER |
|
|
|
|
| |
|
| MAIN A OR B:4ΩMIN. /SPEAKER |
|
|
|
|
| |
|
| A | B:8ΩMIN. /SPEAKER |
|
|
|
|
|
|
| REAR SINGLE:8ΩMIN. /SPEAKER |
|
|
|
|
| |
|
| REAR | :4ΩMIN. /SPEAKER |
|
|
|
|
|
| CENTER | :8ΩMIN. /SPEAKER |
|
|
|
|
| |
|
| MAIN A OR B:8ΩMIN. /SPEAKER |
|
|
|
|
| |
|
| A | B:I6ΩMIN ./SPEAKER |
|
|
|
|
|
MAINS
I00W MAX. TOTAL
SWITCHED
AC OUTLETS
(General model)
WARNING
Do not change the IMPEDANCE SELECTOR switch setting while the power to this unit is on, otherwise this unit may be damaged.
IF THIS UNIT FAILS TO TURN ON WHEN THE POWER SWITCH IS PRESSED
The IMPEDANCE SELECTOR switch may not be set to either end closely. If so, set the switch to either end closely.
(Upper position)
Rear: If you use one rear speaker, the impedance of the speaker must be 6Ω or higher.
If you use two rear speakers, the impedance of each speaker must be 3Ω or higher.
Center: The impedance of the center speaker must be 6Ω or higher.
Main: If you use one pair of main speakers, the impedance of each speaker must be 4Ω or higher.
If you use two pairs of main speakers, the impedance of each speaker must be 8Ω or higher.
(Lower position)
Rear: If you use one rear speaker, the impedance of the speaker must be 8Ω or higher.
If you use two rear speakers, the impedance of each speaker must be 4Ω or higher.
Center: The impedance of the center speaker must be 8Ω or higher.
Main: If you use one pair of main speakers, the impedance of each speaker must be 8Ω or higher.
If you use two pairs of main speakers, the impedance of each speaker must be 16Ω or higher.
ABOUT THE ACCESSORY TERMINALS
Use these to connect the power cords from your components to this unit.
The power to the SWITCHED outlets is controlled by this unit’s POWER switch or the provided remote control transmitter’s POWER key. These outlets will supply power to any component whenever this unit is turned on.
The maximum power (total power consumption of components) that can be connected to the SWITCHED AC OUTLETS is 100 watts.
Connecting the ground wire of the turntable to the GND terminal will normally minimize hum, but in some cases better results may be obtained with the ground wire disconnected.
10