BPHONES jack

PHONES

When you listen with headphones,

 

connect the headphones to the

 

PHONES jack. You can listen to

 

the sound to be output from the

 

main speakers through headphones.

 

When listening with headphones

 

privately, set both the SPEAKERS A

 

and B switches to the OFF position

 

and switch off the digital sound field processor by pressing the SUR/KARAOKE EFFECT button on the front panel or the EFFECT ON/OFF key on the remote control transmitter.

CSPEAKERS switches

Set the switch A or B (or both A and B) for the main speaker system (connected to this unit) you will use to the ON position. Set the switch for the main speaker system you will not use to the OFF position.

DA/B/C/D/E button

Press this button to select a desired group (A–E) of preset stations.

EPreset station number selector buttons Select a preset station number (1 to 8).

FTone controls

These controls are effective only for the sound from the main speakers.

BASS

Used to increase or decrease the low frequency response. The 0 position produces flat response.

TREBLE

Used to increase or decrease the high frequency response. The 0 position produces flat response.

GBALANCE control

Adjusts the balance of the output volume to the left and right speakers to compensate for sound imbalance caused by speaker location or listening room conditions.

HCENTER LEVEL control

Adjusts the sound output level of the center speaker.

IREAR LEVEL control

\Adjusts the sound output level of the rear speakers.

JFM/AM button

Press this button to switch the reception band to FM or AM.

KMEMORY (MAN’L/AUTO FM) button

When this button is pressed, the MEMORY indicator flashes for about 5 seconds. During this period, select a desired preset station number by pressing the corresponding preset station number selector button to enter the displayed station into the memory.

When this button is pressed and held for about 3 seconds, the automatic preset tuning begins. (Refer to page 24 for details.)

LEDIT button

This button is used to exchange the places of two preset stations with each other.

NTUNING MODE (AUTO/MAN’L MONO) button Press this button to switch the tuning mode to automatic or manual. To select the automatic tuning mode, press this button so that “AUTO” lights up on the display. To select the manual tuning mode, press this button so that “AUTO” goes off.

OVOCAL AID button

This button functions only when a DSP program for Karaoke, BALLAD, POPS, JAZZ or ROCK is selected, or the DSP is turned off (so that “E. OFF” appears on the display). Pressing this button so that “VOCAL AID” lights up on the display turns this function on, and whenever this button is pressed, one of three audio output modes is selected in turn. When the “VOCAL CUT” mode is selected, while playing a source, medium frequencies (vocals, etc.) of the source sound are attenuated only when there is an input from the microphone.

To cancel this function, press this button once or more until “VOCAL AID” goes off from the display.

This button is useful for singing Karaoke using a normal audio source with vocals or a multisound source for Karaoke use.

PKEY CONTROL button

This button functions only when a DSP program for Karaoke, BALLAD, POPS, JAZZ or ROCK is selected, or the DSP is off. Pressing this button changes key of the tune currently playing. The current key level is shown on the display.

(Left side): Whenever this side is pressed, key of the track becomes lower.

(Right side): Whenever this side is pressed, key of the track becomes higher.

QONE TOUCH KARAOKE button

This button functions only when a DSP program for Karaoke, BALLAD, POPS, JAZZ or ROCK is selected, or the DSP is turned off (so that “E. OFF” appears on the display). Pressing this button so that “ONE TOUCH KARAOKE” lights up on the display turns this function on, and whenever this button is pressed, one of three audio output modes is selected in turn. When the “VOCAL CUT” mode is selected, medium frequencies (vocals, etc.) of the playing source sound are attenuated.

To cancel this function, press this button once or more until “ONE TOUCH KARAOKE” goes off from the display.

This button is useful for singing Karaoke using a normal audio source with vocals or a multisound source for Karaoke use.

RMIC jacks

One or two microphones can be connected to these jacks. These are available when a DSP program for Karaoke, BALLAD, POPS, JAZZ or ROCK is selected, or the DSP is off.

SMIC LEVEL control

This control functions only when a DSP program for Karaoke, BALLAD, POPS, JAZZ or ROCK is selected, or the DSP is off. This control adjusts the level of sound signals input from the microphone(s) connected to this unit’s MIC jacks.

TECHO level control

English

MTUNING DOWN/UP button

Used for tuning. Press the “UP” side to tune in to higher frequencies, and press the “DOWN” side to tune in to lower frequencies.

This control functions only when a DSP program for Karaoke, BALLAD, POPS, JAZZ or ROCK is selected, or the DSP is off. This control adjusts the level of echo applied to sound signals input from the microphone(s) connected to this unit’s MIC jacks.

13