CONNECTIONS

Speaker connections

Be sure to connect the left channel (L), right channel (R), “+” (red) and “–” (black) properly. If the connections are faulty, no sound will be heard from the speakers, and if the polarity of the speaker connections is incorrect, the sound will be unnatural and lack bass.

CAUTION

Use speakers with the specified impedance shown on the rear panel of this unit.

Before connecting the speakers, make sure that the power of this unit is off.

Do not let the bare speaker wires touch each other or do not let them touch any metal part of this unit. This could damage this unit and/or speakers.

Use magnetically shielded speakers. If this type of speakers still creates the interference with the monitor, place the speakers away from the monitor.

Connecting to the FRONT A SPEAKERS terminals

A speaker cord is actually a pair of insulated cables running side by side. One cable is colored or shaped differently, perhaps with a stripe, groove or ridges. Connect the striped (grooved, etc.) cable to the “+” (red) terminals on this unit and your speaker. Connect the plain cable to the “–” (black) terminals.

10 mm

 

1

2

Red: positive (+)

4

Black: negative (–)

3

 

5

1Remove approximately 10 mm of insulation from the end of each of the speaker cables.

2Twist the exposed wires of the cable together to prevent short circuits.

3Loosen the head of the screw.

4Insert one bare wire into the hole in the side of each terminal.

5Tighten the head of the screw to secure the wire.

Connecting to the FRONT B, CENTER and SURROUND SPEAKERS terminals

Red: positive (+)

Black: negative (–)

1

3 2

1Press and open the tab.

2Insert one bare wire into the hole of each terminal.

3Release the tab to secure the wire.

16