Yamaha RX-V630RDS owner manual Input modes and indications

Input modes and indications

This unit comes with a variety input jacks. You can select the type of input signals you desire.

Each time you turn on the power of this unit, the input mode is set according to “8 INPUT MODE” setting on the SET MENU (see page 47 for details).

1 Press INPUT MODE (the input selector button that you have pressed to select the input source on the remote control) repeatedly until the desired input mode is shown on the front panel display.

		CD	MD/CD-R	TUNER
	INPUT MODE	DVD	D-TV/CBL	V-AUX
	or
		VCR	VCR2/DVR
	Front panel	Remote control
	VCR2/DVR VCR1 V-AUX D-TV/CBL	DVD MD/CD-R	TUNER	CD
				VOLUME
	DVD	AUTO		L R
		Input mode
AUTO:	In this mode, the input signal is selected
	automatically as follows:

	1) Digital signal
	2) Analog signal
DTS:	In this mode, only the digital input signal
	encoded with DTS is selected, even if
	another signal is input at the same time.
ANALOG:	In this mode, only the analog input signal is
	selected, even if a digital signal is input at
	the same time.

Notes

•When AUTO is selected, this unit automatically determines the type of signal. If this unit detects a Dolby Digital or DTS signal, the decoder automatically switches to the appropriate setting.

•When playing a disc encoded with Dolby Digital or DTS on some LD or DVD players, the sound output delays for a moment when playback resumes after a search because the digital signal is selected again.

•When playing a LD source that has not been digitally recorded, the sound may not be output for some LD players. In this case, set the input mode to ANALOG.

BASIC PLAYBACK

■Notes on 96-kHz sampling digital signals

The digital input jacks of this unit can handle 96-kHz sampling digital signals. Note the following when 96-kHz sampling digital signal is input to this unit:

–DSP programs cannot be selected.

–Sound will be output as 2-channel stereo from only the main left and right speakers. (There may be sound output from the subwoofer depending on the SPEAKER MODE settings on the SET MENU.) Therefore, the level of the effect speakers cannot be adjusted while listening to such a source.

■Notes on playing DTS-CD/LDs

•If the digital output data of the player has been processed in any way, you may not be able to perform DTS decoding even if you make a digital connection between this unit and the player.

•If you play a source encoded with a DTS signal and set the input mode to ANALOG, this unit may reproduce the noise of an unprocessed DTS signal. In this case, connect the source to a digital input jack and set the input mode to AUTO or DTS.

•If you switch the input mode to ANALOG while playing a source encoded with a DTS signal, this unit reproduces no sound.

•If you play a source encoded with a DTS signal with the input mode set to AUTO;

–This unit automatically switches to the DTS- decoding mode (The “t” indicator lights up) after having detected the DTS signal. When playback of the DTS source is completed, the “t” indicator may flash. While this indicator is flashing, only DTS source can be played. If you want to play a normal PCM source soon, set the input mode back to AUTO.

–When the input mode is set to AUTO and a search or skip operation is performed during playback of a DTS source, the “t” indicator may flash. If this status continues for longer than 30 seconds, this unit will automatically switch from “DTS-decoding” mode to PCM digital signal input mode. The “t” indicator will turn off.

OPERATION BASIC

English

25