ON-SCREEN DISPLAY (OSD)
You can display operational information for this unit on a video monitor. It is much easier to see the available options and parameters on a monitor than by reading this information on the front panel display.
y
•If a video source is playing, the OSD is superimposed over the video image.
•The OSD signal is not output to the OUT (REC) jack, and will not be recorded with any video signal.
•You can set the OSD to turn on (gray background) or off when there is no video signal using “OPTION 1 DISPLAY SET” on the set menu.
■OSD modes
You can select the amount of information shown in the
Full display
This mode shows the DSP program parameter settings continuously on the video monitor.
Short display
This mode briefly shows the front panel display message at the bottom of the screen and then disappears.
Display off
This mode briefly shows “DISPLAY OFF” at the bottom of the screen and then disappears. In this mode, no operational information is shown on the monitor, except when ON SCREEN is pressed.
P01 CONCERT HALL
≥ DSP LEVEL…………0dB
INIT.DLY…………45ms
ROOM SIZE…………1.0
LIVENESS…………………5
P01 | CONCERT HALL |
| DSP LEVEL…………0dB |
Full display | Short display |
y
•When you choose the full display mode, INPUT, VOLUME and other operational information is displayed at the bottom of the screen, in the same format as on the front panel display.
•The set menu and test tone display appear regardless of the OSD mode.
■Selecting the OSD mode
|
|
| SELECT |
|
POWER |
| POWER | AMP | 2 |
TV |
| AV |
| |
REC |
|
|
|
|
|
| AUDIO | + |
|
DISC SKIP |
|
|
| |
|
|
| VOL |
|
|
|
| – |
|
LEVEL | + | SET MENU | MUTE |
|
TITLE | MENU |
|
| |
TV INPUT | TV VOL | A/B/C/D/E |
|
|
|
|
| ||
CH | TV MUTE | CH |
| 3 |
– | SELECT | + |
| |
PRESET |
| PRESET |
| |
TEST | TV VOL | ON SCREEN | STEREO | |
RETURN | – | DISPLAY |
|
|
EFFECT
1 Turn on the video monitor connected to this unit.
2 Press AMP to set the remote control in AMP mode.
Check that “AMP” is showing in the display on the remote control.
3 Press ON SCREEN repeatedly to change the display mode.
The OSD mode changes in the following order: full display, short display, and display off.
Notes
•The OSD will not display if your video monitor is only connected to the COMPONENT VIDEO jacks of this unit. Be sure to connect your video monitor to the COMPONENT VIDEO jacks and either the VIDEO or the S VIDEO jacks if you want to see the OSD.
•Playing back video software that has an
(When using two video monitors)
•If you select video source from a component connected to both the S VIDEO IN and composite VIDEO IN jacks, and both the S VIDEO OUT and the composite VIDEO OUT jacks are connected to two different monitors, the OSD is only displayed on the monitor connected to the
PREPARATION
English
19
