ABOUT THE ACCESSORY TERMINALS
AC OUTLET(S) (SWITCHED)
(U.S.A., Canada and General models)
........................................................... | 2 SWITCHED OUTLETS |
(Australia model) ................................. | 1 SWITCHED OUTLET |
Use these to connect the power cords from your components to this unit.
The power to the SWITCHED outlets is controlled by this unit’s POWER switch or the provided remote control transmitter’s POWER key. These outlets will supply power to any component whenever this unit is turned on.
The maximum power (total power consumption of components) that can be connected to the SWITCHED AC OUTLET(S) is 120 watts.
GND terminal (For turntable use)
Connecting the ground wire of the turntable to this terminal will normally minimize hum, but in some cases better results may be obtained with the ground wire disconnected.
LOW PASS terminal
This terminal is for output to a monaural amplifier driving a subwoofer. Only frequencies below 200 Hz from the front and center channels are output.
ADDING A SUBWOOFER
You may wish to add a subwoofer to reinforce the bass frequencies.
Connect the LOW PASS terminal to the INPUT terminal of the subwoofer amplifier, and connect the speaker terminals of the subwoofer amplifier to the subwoofer.
With some subwoofers, including the Yamaha Active Servo Processing Subwoofer System, the amplifier and subwoofer are in the same unit.
OUTPUT
FRONT CENTER REAR
LOW
PASS
fc:200Hz
Subwoofer system
FRONT OUTPUT terminals
These terminals are for front channel line output. There is no connection to these terminals when you use the
However, if you drive front speakers with an external stereo power amplifier, connect the input terminals of the external amplifier (MAIN IN or AUX terminals of a power amplifier or an integrated amplifier) to these terminals.
REAR OUTPUT terminals
These terminals are for rear channel line output. There is no connection to these terminals when you use the
However, if you drive rear speakers with an external stereo power amplifier, connect the input terminals of the external amplifier (MAIN IN or AUX terminals of a power amplifier or an integrated amplifier) to these terminals.
CENTER OUTPUT terminal
This terminal is for center channel line output. There is no connection to this terminal when you use the
10