3Connecting speakers/subwoofer

•Under its default settings, the unit is configured for 8-ohm

speakers. When connecting 6-ohm speakers, set the unit’s speaker impedance to “6 Ω MIN”. For details, see “Setting the speaker impedance” in “Owner’s Manual”.

•Use a subwoofer equipped with built-in amplifier.

•Before connecting the speakers, remove the unit’s power cable from the AC wall outlet and turn off the subwoofer.

•Ensure that the core wires of the speaker cable do not touch each other or come into contact with the unit’s metal areas. This may damage the unit or the speakers. If the speaker cables short circuit, “Check SP Wires” will appear on the front display when the unit is turned on.

■Connecting speaker cables

1 Connect the front speakers (1/2)2 Connect the center speaker (3) to the
to the FRONT (//\) terminals.CENTER terminal.

 

XTRA SP

 

XTRA SP

 

ZONE2 F PRESENCE

 

ZONE2 F PRESENCE

The unit (rear)

The unit (rear)

 

SPEAKERS

 

SPEAKERS

FRONT

CENTERSURROUNDSURROUND BACK B -AMP

FRONT

CENTERSURROUNDSURROUND BACK B -AMP

 

SINGLE

 

SINGLE

2

 

2

 

SUBWOOFER

 

SUBWOOFER

 

Speaker cables have two wires. One is for connecting the negative (–) terminals of the unit and the speaker, and the other is for the positive (+) terminals. If the wires are colored to prevent confusion, connect the black wire to the negative and the other wire to the positive terminals.

aRemove approximately 10 mm (3/8”) of insulation from the ends of the speaker cable and twist the bare wires of the cable firmly together.

c

+ (red) bFRONT

d a

– (black)

1

2

1

2

9

3

9

3

b Loosen the speaker terminal.

c Insert the bare wires of the cable into the gap on the side (upper right or bottom left) of the terminal.

d Tighten the terminal.

Using a banana plug

4

5

4

5

(U.S.A., Canada, China, Australia and General models only)

a Tighten the speaker terminal.

a

Banana plug

b

FRONT

b Insert a banana plug into the end of the terminal.

En 3