3Use the cursor keys to select “Save/Cancel” and press ENTER.

4Use the cursor keys to select “SAVE” and press ENTER.

5Disconnect the YPAO microphone from the unit.

This completes optimization of the speaker settings.

•The YPAO microphone is sensitive to heat, so should not be placed anywhere where it could be exposed to direct sunlight or high temperatures (such as on top of AV equipment).

If “W-1:Out of Phase” appears

Follow the procedure below to check the speaker connections.

a Use the cursor keys to select “Result” and press ENTER.

b Use the cursor keys to select “Wiring”.

c Check the cable connections (+/–) of the speaker that was identified as being “Reverse” in the warning message.

If the speaker is connected correctly:

Depending on the type of speakers or room environment, this message may appear even if the speakers are connected correctly.

In this case, you can ignore the message.

Press RETURN and proceed to step 3.

If the speaker is connected incorrectly:

Turn off the unit, reconnect the speaker cable, and then try YPAO measurement again.

En 7