TX6n/5n/4n Owner’s Manual
11
Audio I/O Settings
The TXn can be operated in one of three audio input/output modes: Stereo mode, Parallel mode, or Bridge mode.
Make audio input/output connections and settings as follows.
• With the factory settings, if both analog and digital (input from the slot) signals are input simultaneously, the two signal will be
mixed and output. This setting can be changed from the panel of the TXn or via Amp Editor. For details on making this setting,
refer to “TX6n/5n/4n Reference Manual” or “Amp Editor Owner’s Manual.”
• Use 110-ohm AES/EBU digital cables for digital audio connections. Using analog cables may degrade the sonic quality.
Channels A and B (analog) or channels 1 and 2 (digital) will
operate independently in stereo.
5-way binding post connectors
Speakon connectors
• Each of 5-way binding post connectors and Speakon
connectors are internally parallel-connected. When
using both connectors simultaneously, total speaker
impedance of each connector must be 4–16
Ω
.
The amplifier will operate as a two-channel monaural amp,
with the input signal of channel A (analog) or channel 1
(digital) as the source. Channel B (analog) and channel 2
(digital) will not be used.
5-way binding post connectors
Speakon connectors
• Each of 5-way binding post connectors and Speakon
connectors are internally parallel-connected. When
using both connectors simultaneously, total speaker
impedance of each connector must be 4–16
Ω
.
NOTE
Stereo Mode
–
+
–
+
Analog input
Digital input
Total speaker
impedance:
2–8Ω
Total speaker
impedance:
2–8Ω
Analog input
Digital input
Total speaker
impedance:
2–8Ω
Total speaker
impedance:
2–8Ω
NOTE
Parallel Mode
–
+
–
+
Analog input
Digital input
Total speaker
impedance:
2–8Ω
T
otal speaker
impedance:
2–8Ω
Analog input
Digital input
Total speaker
impedance:
2–8Ω
T
otal speaker
impedance:
2–8Ω
NOTE