TX6n/5n/4n Owner’s Manual
8
Firmware Updates
The firmware version of the TXn itself can be checked from the TXn’s panel and from Amp Editor. You can
update the firmware via Amp Editor. For the update procedure, refer to the Amp Editor Owner’s Manual.
You can download the latest firmware from the “Downloads” page on the following website.
http://www.yamahaproaudio.com/
Preparation
•Be sure to turn all devices OFF before connecting
AC mains power.
Insert the plug into an AC outlet. Be sure to use an AC outlet
of the voltage specified for the device.
•To prevent the initial power-on surge from gener-
ating a large noise spike or damaging your
speaker system, turn the devices on in the follow-
ing order: audio sources, mixer (such as M7CL or
PM5D), and finally power amplifiers. Reverse this
order when turning power off.
1.
Press the front panel [POWER] switch to the
“ON” position to turn the power on.
2.
Press the [POWER] switch to the “OFF” position
to turn off the power.
• The settings at the time you powered-off are
remembered. When you turn on the power to the
TXn, it will start up with the same settings. You
can use the “Last Mem. Resume” setting to set up
the TXn so that at startup it will recall the scene
number selected before you turned off the power
to the device.
• Do not turn off the power while the upper part of
the display indicates “Do Not Turn Off!” Other-
wise, a malfunction may occur.
•A small amount of current is flowing even when
the power switch is off. If you will not be using
this device for an extended period of time, be
sure to disconnect the power plug from the AC
outlet.
1.
Hold down the panel [HOME] button for at least
three seconds.
The TXn’s display will show the HOME screen, and
then a message of “Turning power on: Are you sure?”
or “Going Standby: Are you sure?” will appear.
2.
Press the panel [ENTER] button, and the power
status will switch between Standby and On.
• Standby is a state in which the speaker output’s
power amp section is off (operation other than
speaker output will continue).
Hold down the [MUTE] button of the channel you
want to mute for at least one second.
The channel’s output will be muted, and the [MUTE] indica-
tor will light.
To switch mute off, press the [MUTE] button again for at
least one second.
Function buttons [HOME] button
[MUTE] buttons
[POWER] switch [ENTER] button
Connecting the AC Power Cable
Turning the Power on and off
CAUTION
CAUTION
NOTE
CAUTION
CAUTION
Switching the Power Status between
Standby and On
Switching Mute on/off
NOTE