Yamaha UX256 - page 17

Installing the Driver

•Selecting the destination for the MIDI signal output

This section explains how to set up the UX256 for use with Media Player (included in

Windows 98) or an equivalent program. For information on setting up your sequence

software, refer to the owner’s manual for the software.

1. Click “Multimedia” in the Control Panel to open the Multimedia Proper-

ties window.

2. Click the “MIDI” tab and check to see if “Yamaha USB OUT xx-yy” is listed.

“xx” means the device number (page 26) and “yy” means the port number

(page 24). If only one UX256 is connected, the device number is “0.”

3. While “Single instrument” is selected, select a driver according to the

port number of the connected tone generator, and click [OK].

•Connecting multiple UX256s

Follow the steps below to connect two or more UX256s. You do not need to install the

driver again.

1. Start the computer.

2. Make sure the power to the UX256s is turned off (standby). Connect the

USB terminal of the computer or the USB hub to the USB terminal on the

UX256s using the USB cables.

3. Turn on the power to the UX256s.

When you turn on the power to connected multiple UX256s, the device

number is assigned, starting with 0, to the units in the order in which you

turn on the power. If you turn on the power to all units simultaneously, the

device number is assigned based on the order of the port numbers of the

USB hub. However, this order may change depending on the hub.

NOTE