Yamaha UX256 Changing the driver set- ting (MIDI Patch Screen)

Changing the driver set-ting (MIDI Patch Screen)

You can change the assignment of I/O connectors on the UX256 and port numbers

selected from the computer.

Sequence software transmits and receives MIDI signals to and from the UX256 via the

driver (page 13). The UX256 is equipped with six MIDI IN/OUT terminals and two TO

TG terminals. You specify the I/O ports of the UX256 to control from the computer’s

sequence software. At this time, changing the driver setting enables you to change

these I/O assignments without re-patching the cables.

For example, you can transmit an identical MIDI signal to multiple ports or transmit

layered MIDI signals from multiple ports to a single port. Also, you can directly route

MIDI signals from MIDI IN to MIDI OUT.

The following table shows the assignment of the port numbers and I/O ports. With the

default settings, the port number matches the computer’s port number.

If a tone generator connected to the TO TG port does not support multi-port

speciﬁcations, the selection of ports B-E will be ignored.

port number MIDI output port MIDI input port

Port 1 MIDI OUT1 MIDI IN1

Port 2 MIDI OUT2 MIDI IN2

Port 3 MIDI OUT3 MIDI IN3

Port 4 MIDI OUT4 MIDI IN4

Port 5 MIDI OUT5 MIDI IN5

Port 6 MIDI OUT6 MIDI IN6

Port 7 TO TG1 -A TO TG1

Port 8 TO TG1 -B TO TG2

Port 9 TO TG1 -C

–

Port 10 TO TG1 -D

–

Port 11 TO TG1 -E

–

Port 12 TO TG2 -A

–

Port 13 TO TG2 -B

–

Port 14 TO TG2 -C

–

Port 15 TO TG2 -D

–

Port 16 TO TG2 -E

–

NOTE