Yamaha UX96 The UX96 does not operate correctly, or no sound is heard., Playback response is delayed., Cannot suspend or resume the computer correctly.

● The UX96 does not operate correctly, or no sound is heard.

•Did you install the driver? (page 10)

•Are the USB cable, MIDI cables, serial cables, and audio cables connected

correctly? (page 9)

•Is the volume setting of the tone generator, playback device, and applica-

tion program set to the appropriate level?

•Is the HOST SELECT switch on the tone generator set correctly?

→If the tone generator is connected to the MIDI IN/OUT terminals, set the switch

to “MIDI.” If the tone generator is connected to the TO TG/INST terminal, set the

switch to “PC-1” or “Mac,” regardless of the computer you are using.

•Have you selected an appropriate port in the sequence software?

● Playback response is delayed.

•Does your computer satisfy the system requirements? (page 7)

•Is any other application or device driver running?

[Macintosh]

→Turn off virtual memory.

→Disable AppleTalk.

● Cannot suspend or resume the computer correctly.

•Do not suspend the computer while the MIDI application is running.

•If you are using Windows 2000, Save Energy mode may be disabled

depending on your environment (USB Host Controller etc.) Even in this

case, if you disconnect and connect the USB cable, UX96 functions will be

enabled again.