31
Getting Started
Setting Up
Setting Up
Load the Pre-programmed Voice Data
Although the factory pre-programmed voices, performance combinations, and
patterns are stored in the VL1 internal memory when the instrument is initially shipped,
there is always a possibility that all or part of the memory has been erased or modified by
the time the instrument gets to you. Here’s how you can re-load all the pre-programmed
data from the supplied voice disk.
NOTES Loading the pre-programmed voices overwrites any other data that is
in the VL1 internal memory, so if you have any important voices in memory make
sure it is safely stored to disk before loading the data — Feature Reference
manual, page 166.
1. Insert the Voice Disk
Insert the voice disk into the disk drive. The sliding disk shutter should go in first,
and the label side of the disk should face upward.
2. Select the Utility Mode System Page
Press the U button to select the utility mode. Then, if it is not already se-
lected when the utility mode display appears, press the ¡ button to select the “Sys-
tem” function page.
3. Go To the Miscellaneous Page & Turn Memory Protect Off
Use the cursor buttons to move the cursor to “6:Miscellaneous”, then press
[ to call the “Miscellaneous” function page.
Use the cursor buttons to select the “Memory Protect” parameter, then press
= to turn memory protect “off”.