22 Chapter 2—Control Surface & Rear Panel
DM2000 Version 2—Owner’s Manual
DSOLO buttons
These buttons are used to solo Channels. The [SOLO] button indicators of channels that
are soloed light up. See “Soloing Channels” on page 142 for more information.
EON buttons
These buttons are used to mute Input and Output Channels. Their exact operation depends
on the currently selected Layer. The [ON] button indicators of channels that are on light up.
You can also use these buttons along with the AUX SELECT buttons to turn Aux Sends on
and off (Mix Minus) (page 117).
FChannel strip displays
These fluorescent displays graphically display the value of the Input or Output Channel
parameter currently assigned to the Encoders. They also display routing settings, and the
on/off status of the EQ, Insert, Delay, Comp, and Gate functions. They also display Long
and Short channel names and indicate the currently selected channel. When you operate
the channel faders or Encoders, they display the corresponding values. See “Channel Strip
Displays” on page 55 for more information.
GChannel faders
These 100 mm touch-sensitive motorized faders are used to set the levels of Input Channels,
Bus Outs, Aux Sends, and Matrix Sends. Their exact operation depends on the currently
selected Fader mode and Layer. See “Selecting Fader Modes” on page 60 for more informa-
tion. Faders can be grouped for simultaneous operation. See “Grouping Input Channel
Faders” on page 91 and “Grouping Output Channel Faders” on page 146 for more informa-
tion.
Faders can also be used to select Input and Output Channels. See “Auto Channel Select &
Touch Sense Select” on page 60 for more information. They can also be used to punch chan-
nels in and out during Automix recording. See “Punching In & Out Individual Parameters”
on page 207 for more information.
Channel faders also enable you to set graphic equalizer curves. See “Editing GEQs” on page
183 for more information.
SmartMedia CARD Slot
This CARD slot is for use with SmartMedia (3.3 V), which can be
used to store DM2000 data, including Setups, Scenes, Automixes,
Libraries, and so on. See “Saving DM2000 Data to SmartMedia” on
page 271 for more information.
MATRIX SELECT
AMATRIX SELECT DISPLAY button
This button is used to select the following pages: Matrix Send, Matrix Send Pan, and Matrix
View. See “Matrix Sends” on page 121 for more information.
BMATRIX 1–4 buttons
These buttons are used to select Matrix Sends when sending Bus Out, Aux Send, and Stereo
Out signals to Matrix Sends. The button indicator of the currently selected Matrix Send
lights up. See “Matrix Sends” on page 121 for more information.
CARD
3.3V
MATRIXSELECT
DISPLAY
MATRIX2MATRIX4MATRIX3
MATRIX1
1
2