FCC INFORMATION (U.S.A.)

1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!

not guarantee that interference will not occur in all installations. If

This product, when installed as indicated in the instructions con-

this product is found to be the source of interference, which can be

tained in this manual, meets FCC requirements. Modifications not

determined by turning the unit “OFF” and “ON”, please try to elimi-

expressly approved by Yamaha may void your authority, granted by

nate the problem by using one of the following measures:

the FCC, to use the product.

Relocate either this product or the device that is being affected by

 

2. IMPORTANT: When connecting this product to accessories and/

the interference.

or another product use only high quality shielded cables. Cable/s

Utilize power outlets that are on different branch (circuit breaker or

supplied with this product MUST be used. Follow all installation

fuse) circuits or install AC line filter/s.

instructions. Failure to follow instructions could void your FCC

In the case of radio or TV interference, relocate/reorient the

authorization to use this product in the USA.

antenna. If the antenna lead-in is 300 ohm ribbon lead, change the

 

3. NOTE: This product has been tested and found to comply with the

lead-in to co-axial type cable.

requirements listed in FCC Regulations, Part 15 for Class “B” digital

If these corrective measures do not produce satisfactory results,

devices. Compliance with these requirements provides a reason-

please contact the local retailer authorized to distribute this type of

able level of assurance that your use of this product in a residential

product. If you can not locate the appropriate retailer, please contact

environment will not result in harmful interference with other elec-

Yamaha Corporation of America, Electronic Service Division, 6600

tronic devices. This equipment generates/uses radio frequencies

Orangethorpe Ave, Buena Park, CA90620

and, if not installed and used according to the instructions found in

The above statements apply ONLY to those products distributed by

the users manual, may cause interference harmful to the operation

Yamaha Corporation of America or its subsidiaries.

of other electronic devices. Compliance with FCC regulations does

 

 

 

* This applies only to products distributed by YAMAHA CORPORATION OF AMERICA.

(class B)

 

 

OBSERVERA!

 

Apparaten kopplas inte ur växelströmskällan (nätet) så länge som den ar

 

ansluten till vägguttaget, även om själva apparaten har stängts av.

 

ADVARSEL: Netspæendingen til dette apparat er IKKE afbrudt, sålæenge

 

netledningen siddr i en stikkontakt, som er t endt — også selvom der or

 

slukket på apparatets afbryder.

 

VAROITUS: Laitteen toisiopiiriin kytketty käyttökytkin ei irroita koko laitetta

 

verkosta.

 

 

 

(standby)

 

This product contains a high intensity lamp that contains a small amount of mercury. Disposal of this material may be regulated due to environmental considerations.

For disposal information in the United States, refer to the Electronic

Industries Alliance web site:

www.eiae.org

* This applies only to products distributed by YAMAHA CORPORATION OF AMERICA.

(mercury)

IMPORTANT NOTICE FOR THE UNITED KINGDOM

Connecting the Plug and Cord

IMPORTANT. The wires in this mains lead are coloured in accordance with the following code:

BLUE : NEUTRAL

BROWN : LIVE

As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured makings identifying the terminals in your plug proceed as follows:

The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK.

The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED.

Making sure that neither core is connected to the earth terminal of the three pin plug.

• This applies only to products distributed by Yamaha-Kemble Music (U.K.) Ltd.

(2 wires)

PSR-S500 Manual de instrucciones 3