189
User Level settings
19
User settings (Security)
LS9-16/32 Owner’s Manual
3Move the cursor to the CREATE USER KEY
button and press the [ENTER] key.
The CREATE USER KEY popup window will appear.
1USER NAME
The user name of up to eight characters is shown (and
can be edited) here. When you move the cursor to this
field and press the [ENTER] key, a keyboard window
will appear, allowing you to enter a user name (→
p. 34).
BPASSWORD
Specify a password of up to eight characters. Press this
to access a keyboard window where you can enter the
password (→ p. 34).
CPOWER USER
Specifies whether Power User privileges will be
granted to this user.
DAccess permission settings
These settings specify the range of operations that the
user can perform. For details on each item, refer to
p.193.
4When you have specified the user name,
password, power user privileges on/off, and
user rights, move the cursor to the CREATE
button and press the [ENTER] key.
If you are logged-in as the Administrator, the user
authentication key will be saved on USB memory.
If you are logged-in as a Power User, a dialog box will
ask you to confirm the store-destination USB memory.
If you want to save the user authentication key on dif-
ferent USB memory, connect the desired USB mem-
ory and then press [OK].
In order to operate the LS9, you must log in as the Admin-
istrator, Guest, or a User.
User settings for the Administrator and Guest are saved in
the console itself, but in order to log in as a User you must
connect USB memory on which a user authentication key
has been saved. If you disconnect the USB memory after
logging-in, your access privileges will forcibly revert to
Guest.
●Logging-in as Administrator
1In the DISPLAY ACCESS section, press the
[SETUP] key repeatedly to access the USER
SETUP screen.
2Move the cursor to the log-in popup button
and press the [ENTER] key.
The LOGIN popup window will appear.
1 2 3
4
Logging-in
•If the power is turned off and then on again, the console will gener-
ally start up in the log-in state in which the power was turned off. If
a user password has been assigned, you will need to enter the
password. However if you cancel the input, you will be forcibly
logged-in as Guest. Similarly, you will also be forcibly logged-in as
Guest if you had been logged-in as a user requiring a user authen-
tication key, but USB memory is no longer connected.
NOTE
Log-in popup button