CONTROLS AND THEIR FUNCTIONS

Front panel

STANDBY/ON

HIGH CUT

VOLUME

 

50 Hz

150 Hz

0

10

 

~

Ÿ

!

 

⁄

 

Rear panel

 

 

 

 

 

POWER

 

 

 

OUTPUT

INPUT2 AUTO

 

 

 

TO SPEAKERS

STANDBY

 

 

 

 

 

ON

OFF

LOW HIGH

@

POWER

OFF

FROM AMPLIFIER

INPUT1

English

~

Ÿ

!

⁄

@

¤

Power indicator

Lights up while this unit is ON.

*If the AUTO STANDBY switch on the rear panel is set to the LOW or HIGH position, this indicator is illumi- nated dimly when no signal is input to this unit.

STANDBY/ON button

Each press of this button turns the unit on and off (on standby). A small amount of power is always consumed even while this unit is on standby.

HIGH CUT control

Adjusts the high frequency cut off point.

Frequencies higher than the frequency selected with this control are all cut off (and not output).

VOLUME control

Adjusts the volume level.

Main POWER switch

Normally, leave this switch to the ON position. When you will not use this unit for a long period, set this switch to the OFF position.

AUTO STANDBY switch

With this switch, you can activate the Automatic Standby function. Normally, set the switch to the LOW position.

To cancel this function, set the switch to the OFF position.

*Change the setting of this switch only when the power of this unit is on standby (by setting the STANDBY/ON button to OFF).

¤

Automatic Standby function

When you play a source, the power of this unit turns on automatically by sensing audio signals input to this unit. This unit turns into the standby mode automatically if the source being played is stopped or the low frequency input signal is cut off for several minutes.

This function will operate by sensing a certain level of low frequency input signal. Its sensitivity is high in the HIGH position and low in the LOW position of the AUTO STANDBY switch. In the HIGH position, the power will turn on even with a low level of input signal, but on the other hand this unit may not turn into the standby mode when there is an input signal even if its level is extremely low.

*There may be a case that the power turns on unexpectedly by sensing noise from other appliances. If it occurs, set the AUTO STANDBY switch to the OFF or LOW position.

*The level of low frequency input signal differs with each source, and each different part on the same source. So, this function may not operate properly depending on some sources.

This function is available only when the power of this unit is on (by setting the STANDBY/ON button Ÿ to ON).

9