PERIODIC MAINTENANCE AND MINOR REPAIR
Tightening torque: Spark plug:
20 Nm (2.0 m•kgf, 14.4 ft•lb)
NOTE:
1
1
If a torque wrench is not available when installing a spark plug, a good estimate of the correct torque is 1/4- 1/2 turn past finger tight. However, the spark plug should be tightened to the specified torque as soon as possible.
4.Install the spark plug cap.
5.Install the panel.
1. Oil filler cap
EAU04228
Final transmission oil
The final transmission case must be checked for oil leakage before each ride. If any leakage is found, have a Yamaha dealer check and repair the scooter. In addition, the final transmission oil must be changed as follows at the intervals specified in the periodic maintenance and lubrication chart.
1.Start the engine, warm it up by riding the scooter for several minutes, and then stop the en- gine.
2.Place the scooter on the centerstand.
1.Drain bolt
3.Place an oil pan under the final transmission case to collect the
used oil.
4. Remove the oil filler cap and 6 drain bolt to drain the oil from the final transmission case.
5.Install the final transmission oil drain bolt, and then tighten it to the specified torque.
Tightening torque:
Final transmission oil drain bolt:
18 Nm (1.8 m•kgf, 13 ft•lb)